 |
 |
|
|
| Voidgamers Home | Printer Friendly Version |
|
By CINNA - Dec. 31, 1969 Incense Burner uses sticks, cones or joss sticks (Japanese incense). Plenty of openings allows for air to reach the incense and for smoke to flow out.Comes apart into four sections to ease in the insertion and cleaning of incense. All pieces are from Mold #45, The Basic Dungeon Mold (with the exception of four corner arches from Mold #42, the Gothic Arena Mold). Painted with a dark grey base, medium grey dry-brush, and a very light grey dry-brushed highlights. Flames are yellow with red tips. Made from Excalibur dental stone. Part One: The Incense holder and ash catcher Measurements: 3" by 2" Large Arches: 4 Basic Blocks: 4 Large Arch Fillers: 4 1" Wall Tiles: 2 1/2" Wall Tiles: 4 Part Two: Main Body Measurements: 3" by 3" by 3" 3" Basic Block: 4 Embedded Columns (all three sections): 8 Brazier Halves: 2 (with flame halves) Gates: 4 (glued back to back) Large Arches: 8 Large Arch Fillers: 4 1" Flat Wall Tile: 8 1/2" Flat Wall Tile: 12 Basic Blocks: 4 Part Three: Arched Section Measurements: 3" by 3" by 2" Corner Aches: 4 (from mold #42) Small Arches: 8 Flat Wall Tiles: 10 Basic Blocks: 4 3/4" Basic Block: 16 Small Arch Fillers: 16 Part Four: Top Section Measurements: 2.5" by 2.5" by 2" (approximately) Flat Wall Tiles: 6 1/2" Flat Wall Tiles: 8 Small Archs: 4 1/2" Basic Block: 8 Basic Block: 2 Braziers (full set): 4 (tops cut off w/flames added) Small Arch fillers: 12 To see a fully turning 3D image of the Incense Burner with Smoke coming out the top go here: http://www.wizkeep.com/castlecreations/FinishedBurner.htm
You must be a registered member to post comments. You may sign-in Here. |
| Shortcuts |
 |  Voidgamers Home |
|
|
